HotelSixActual
New Member
TM Sig 552, KWC Caspian .45 Owned: TM M4A1, KSC Glock 18c, KWC Glock 17
Posts: 816
|
Post by HotelSixActual on Nov 24, 2003 23:46:33 GMT -5
I just got a glock exstended mag in from HK and when i went to go put a bb in it........it wouldnt fit. The BB port was to small to fit the bb. It looks a little bit like the metal might have been bent a little but im not sure, it might just be defective. Has anyone else had this problem or am i just stupid and is there something obvious i missed?
|
|
|
Post by Knief on Nov 25, 2003 12:11:18 GMT -5
can you get a picture of the front and top of the mag?
If there is something bent, you may be able to unbend it. But if you are just not seeing something, it would be nice to catch it before ou take some plyers to your mag.
|
|
|
Post by Jacko on Nov 25, 2003 12:18:35 GMT -5
Even if that part is bent, you should be able to get a replacement for it fairly easily/cheaply.
|
|
HotelSixActual
New Member
TM Sig 552, KWC Caspian .45 Owned: TM M4A1, KSC Glock 18c, KWC Glock 17
Posts: 816
|
Post by HotelSixActual on Nov 25, 2003 13:05:50 GMT -5
|
|
|
Post by luke213 on Nov 25, 2003 13:41:03 GMT -5
I wouldn't bend that part at all, as it will likly break we're not talking about quality metal here. I would just dremel it out a little, it looks like the mold didn't work very well. So dremel away, otherwise you could drill it, or file it or anything else:)
Luke
|
|
|
Post by Munin on Nov 25, 2003 15:17:33 GMT -5
Or just complain to whomever you bought it from and get them to send you a new one.
|
|
HotelSixActual
New Member
TM Sig 552, KWC Caspian .45 Owned: TM M4A1, KSC Glock 18c, KWC Glock 17
Posts: 816
|
Post by HotelSixActual on Nov 25, 2003 15:21:00 GMT -5
Yeah thats what im probebly going to do but im not sure.
|
|