Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Dec 22, 2014 23:12:39 GMT -5
Hello, I would like to re wire my fusion engine to the front of my gun from the stock/buffer tube. I have been searching all over the internet but have found nothing. So, I tried to do it my self but did not get very far. So, my questions are:
How to re wire a FE to the front of your gun
And, can I disconnect the FCU by pulling the wires from it? It appears there is a connector but I don't want to risk breaking it. (Also found no info on this as well)
Thanks!
|
|
Simon
New Member
Posts: 379
|
Post by Simon on Dec 23, 2014 9:10:53 GMT -5
This guy does a great informational video set about the FE, SMP and V12. Here is the link to the FE video: Bingo Airsoftworks HPA Engine Review, Part 1 of 3…: youtu.be/rroR2_hi_Uo
|
|
Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Dec 23, 2014 13:04:20 GMT -5
This guy does a great informational video set about the FE, SMP and V12. Here is the link to the FE video: Bingo Airsoftworks HPA Engine Review, Part 1 of 3…: youtu.be/rroR2_hi_UoThis video answered all of my questions and then some. I got it wired to the front hand guard, but ran into a problem with the delta ring (I don't own the tool) :/. So I had to brain storm and did this instead with the wire. Thanks! Attachments:
|
|
|
Post by Stinger on Dec 24, 2014 21:58:44 GMT -5
I believe you need an AR-wrench. The delta ring is one of the many reasons that I hate M4A1s.
|
|