Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Oct 20, 2014 10:58:48 GMT -5
Not sure exactly where this thread belongs but this section seems appropriate.
I have been thinking about doing some trademarks on my airsoft replica since there are no trade marks on it. I have searched around and have found nothing about doing trade marks really. So, I was wondering if anyone on here would know how to do these and have them be for the most part permanent. All I can think of so far is hole punching a paper with the letters/number I would like then using some white spray paint to paint them on. My only concerns are A, I would screw up and B, it would not stay very long. Thanks for your guys help and suggestions in advance!
|
|
|
Post by Kjones on Oct 20, 2014 23:16:37 GMT -5
Someone on thee forums owns a laser etcher. Find him or someone else and this will be your best looking and longest lasting solution.
|
|
Gabriel
New Member
The face of a man who has seen the Ancient Ones is forever twisted by the memory.
Posts: 455
|
Post by Gabriel on Oct 21, 2014 5:36:38 GMT -5
I know Slapjack used to offer laser engraving, but he is hard to get ahold of during the school year. My buddy thedesiel might be able to (you can find him on the guide to shipping sticky), but it would be faster to have me ask him since he doesn't come on the forums much anymore.
|
|
Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Oct 21, 2014 6:07:03 GMT -5
How much would it cost to have it laser engraved? I am very interested in this
|
|
|
Post by Squirrel on Oct 21, 2014 8:52:29 GMT -5
I have a lower that somebody crudely etched some sort of fire chicken into with a car key or something equally barbaric. I might suggest not doing that, because it took me a long time to sand it out.
|
|