|
Post by BUZZSAWW (S.O.C) on May 8, 2012 21:12:57 GMT -5
I have a jg m4 614 and I was looking to get a madbull ultimate hopup unit. The only thing is my jg needs a mod to fit it. What am I going to have to mod to make it work and why?
|
|
|
Post by Ike on May 9, 2012 6:11:11 GMT -5
Your JG likely has a 2 piece hopup since it has a plastic body. You'll need to remove the extension part of the hopup that is connected to your lower receiver which should be straightforward. Other than that, I can't be sure of what you'd need to do, but I can't imagine it being difficult at all.
|
|
|
Post by deacon on May 9, 2012 11:34:25 GMT -5
There isn't enough room, even after removing the plastic support from the lower. You need to grind down the hop facing the barrel end to make up for the new 1 piece being longer. It will be a super tight fit and will need to be pushed on to the nozzle before you insert into the lower
|
|