wes
New Member
TM AK-47, P99 springer
Posts: 40
|
Post by wes on Feb 12, 2003 17:26:45 GMT -5
I have a Marushin Raging Bull and I have minor problems that can be easily fixed, but still irretating. For instance about a week after I got it the outer barrel (that has no technical importance other then looks) came off, but all it needed was just a tightend screw. And right now it won't fire in 60-70 degree atmospheres, and the hop up came out . Are these problems common? And are there any others that I should know about? If so there could very likely be another gas gun for sale!
|
|
|
Post by Minky on Feb 12, 2003 17:47:59 GMT -5
What type of gas are you using when it refuses to fire in warm temps? This sounds like it could be a case of gas over-pressure, so if you're using green gas try switching to HFC134a and see if the gun works. If so, the green gas at those temps. is at a higher pressure than the hammer can overcome to release it. I'm not at all familiar with the Raging Bull internals, but it may be possible to increase the hammer spring strength if you want to run green gas at high temps.
|
|
|
Post by Andy on Feb 12, 2003 21:03:40 GMT -5
Wes, Go to ArniesAirsoft.com they have a hole section review on i think you probem, I didnt read it and it wasnt a preformance reveiw.
|
|
wes
New Member
TM AK-47, P99 springer
Posts: 40
|
Post by wes on Feb 14, 2003 17:42:40 GMT -5
I do use primarily green gas.
Any way I went up to WTS with andy and nathan yesterday (Thursday), and Clayton found that a little peice of the frame just infront and on the right side was bent out of allignment. He said that it could have been caused by dropping it (which I don't remember doing). Or pulling it out of a holster it could have been twisted, (which I haven't had a chance to use it in a holster) so I'm pretty sure that I didn't do that. And now that I know that the green gas can produce a lot of pressure I think that that might have caused it.
I left it there and am hoping that it might be ready for the 22nd game. Do you think that this could happen again if I keep using green gas?
|
|
|
Post by Jacko on Feb 16, 2003 0:28:05 GMT -5
On Arnie's site, the reviewer makes it pretty apparent to only use the TM gas. It sounds like that isn't an unfounded piece of advice.
|
|
wes
New Member
TM AK-47, P99 springer
Posts: 40
|
Post by wes on Feb 20, 2003 18:54:35 GMT -5
Could someone type in the ful web site for Arnies Airsoft.com? Since when ever I try to get there I get a message that says that it can't find the URL address.
|
|
|
Post by Knief on Feb 20, 2003 19:01:37 GMT -5
|
|
wes
New Member
TM AK-47, P99 springer
Posts: 40
|
Post by wes on Feb 20, 2003 19:35:27 GMT -5
Hey thanx a lot, I asumed that it was .com instead of whatever it really was.
|
|
WTS-Mike
New Member
Preachah Man
Former Owner of Wolverine Tactical Supply and general all around nice guy
Posts: 577
|
Post by WTS-Mike on Feb 22, 2003 9:21:26 GMT -5
THat gun definitely should use H134a. If you got green by accident clayton might have missed that, but he is usually pretty sharp on stuff like that....
|
|