Post by Gunslinger on Sept 29, 2004 21:59:33 GMT -5
This has been a gun ive had laying around in peices for quite some time.
I origenaly started off with a sr-16 with a v-match that wasnt all there
and the body was shot in the a$$.
I bought a new (used) M-16 A2 body and started the construction. I then needed a fore grip and all that, basicaly from the delta ring foreward.
then I found a M733 front end and began construction again. I loved the look of the V-match so much I wanted to make it work on this set up and seings how I had the parts (most of them) from the old V-match I figured Ide give it a try with the dremel in hand I got to work... Once I cut off some of the V-match barrel cover and notched it so it would fit the shorter M733 fromt inner barrel it started to come together I also had to notch it so the V-match barrel cover went around the carry handle and the mag well, then drilled a hole in the top of the V-match so I could tighten the outter barrel from the M733 in its D ring, But I used the Old SR-16 inner barrel and a problem developed. I had no way to cover that much barrel!, So I went into the scrap closet again and found a plastic silencer that came with my spring P99. And wala! this is the end result!
Its as sturdy as all get out now having done the cutting on the old V-match.
You can see me in the red dot taking this picture.
I origenaly started off with a sr-16 with a v-match that wasnt all there
and the body was shot in the a$$.
I bought a new (used) M-16 A2 body and started the construction. I then needed a fore grip and all that, basicaly from the delta ring foreward.
then I found a M733 front end and began construction again. I loved the look of the V-match so much I wanted to make it work on this set up and seings how I had the parts (most of them) from the old V-match I figured Ide give it a try with the dremel in hand I got to work... Once I cut off some of the V-match barrel cover and notched it so it would fit the shorter M733 fromt inner barrel it started to come together I also had to notch it so the V-match barrel cover went around the carry handle and the mag well, then drilled a hole in the top of the V-match so I could tighten the outter barrel from the M733 in its D ring, But I used the Old SR-16 inner barrel and a problem developed. I had no way to cover that much barrel!, So I went into the scrap closet again and found a plastic silencer that came with my spring P99. And wala! this is the end result!
Its as sturdy as all get out now having done the cutting on the old V-match.
You can see me in the red dot taking this picture.
)
i like what you did with it 
