SSXmac
New Member
Famas F1, Micro UZI, Colt 1911 A1
Posts: 81
|
Post by SSXmac on Apr 17, 2003 22:06:06 GMT -5
I just orderd a tightbore barrel for my Famas, it'll be here in a few weeks (or so im assuming), and i realized that i have no clue how to install it. How is a barallel attached in the gun? are there anythings i should look out for when replacing the barrel? just want some input before i waste a lot more time installing this then is needed.
|
|
|
|
Post by Minky on Apr 17, 2003 22:24:55 GMT -5
I'm not familiar with the FAMAS at all, but this page should help: airsoftplayers.com/manuals.asp Hopefully one of the people here who own the 'MAS can offer some advice on taking it apart. The main thing to watch out for when replacing the barrel on any gun is the hop-up. Be very careful when removing and replacing the hop unit on the barrel. You don't want to tear anything or lose any parts. Also just be careful overall and take things slow, and make sure you know how things are supposed to come apart and go together, before forcing things or stripping screws. Good luck!  |
|
Harley
New Member
Retired Airsofter.
Posts: 86
|
Post by Harley on Apr 17, 2003 23:07:45 GMT -5
From when I took my MAS apart I remember that basically the outer body comes off of the internals and barrell so that that is pretty much all that is left. I haven't done anythign to the mech box or barrel yet so I can't help you there. If you have any questions about how things go together feel free to PM cause I don't plan on tearing mine down anytime soon.
|
|
