Guarder Silencer, not threading all the way

[MayhemXXXFrosty (AndrewMp5k)]

Okay, I just picked up a Guarder Silencer, a Guarder MP5N-S Silencer Special Edition to be exact. So, I wanted to attach it to my KSC G19 via attaching it to my G&G Metal Outer Barrel (14mm) which is positively threaded. The problem is, that it will only thread on about half the way. I can't even screw it in while wrenching with pliers.




Now, the Negative side threads fine onto my SR-16. The only thing I can think of is either G&G messed up on threading my attachment, or Guarder messed up on threading my Positive side of the silencer.

Does anyone have a Positive threaded attachment (14mm) that I could possibily try to narrow down what part is wrong?

[OPFOR]

does a positive flash hider fit on the glock barrel? there are many different measurements other than just the 14mm. the thread pitch for one. if i remember correctly tm and ca outer barrels are 14mmNEGX1.0. the silencer may not be the same measurement.

[O'Dwah]

You could try to tap the silencer more, but be careful not to strip the threads.

[MayhemXXXFrosty (AndrewMp5k)]

My dad was going to do that at his work Echo, but he didn't have a dye set or something along those lines.

And, Opfor, I don't have a positive flash hider, all are Negative threaded to fit my AEGs. And the only silencer that has both positive and negative threading, my teammate drilled the positive side wider, because the BB was hitting the end of the silencer and going all over the place accuracy wise.

[Jacko]

You going to Red Out? If so, I'll bring my 249 flash hider, it's positive.