Polarstar full Upgrade question.

[All-State]

Hello everyone, So I'm looking to fully upgrade my polar-star. I've done a little bit of research and found what I think I'll need.

Here's what I think I will be needing:
1.ProWin - M4 Chamber for M4 (AEG)
2.Prometheus - Hopup Soft Bucking (Purple)
3.ORGA - Magnus 6.23mm Barrel (500mm)
4.HSA - R-Hop (Pack of 3)
5.Fusion Engine Poppet Shims (Pack of 4)
6.PolarStar - Fusion Engine Nozzle for M4/M240 (Red: 500-590 FPS)
7.Polarstar - Fusion Engine Low Flow Poppet (Red/.0625)

Anything else I need or should change?

[Squirrel]

Not a pro on P* to critique the rest of your list, but if you plan to r hop, I've had a bit better success and better consistency when I ran with a harder bucking. Cutting the mound from a hard bucking is a bit more difficult, but it is worth it in the long run.

Also, what is your goal for FPS with this project?

[All-State]

Thank you very much for the insight. Also my goal FPS for this project would be around 520 give or take.

[broken-RS-]

From what I've read on the pstartalk forum, the Orga wide bore barrels haven't shown a huge gain in accuracy with barrels longer than a standard length m4 barrel.(I haven't caught up in the last few months though)

I agree with squirrel, definitely go with a hard bucking for the R-hop. I'd recommend looking into the R-hop system a little more before you order. If you end up wanting to ER-hop, the Prowin doesn't work well. You might want to consider the IR-hop, as it's more temperature tolerant.

I run a Prometheus 550mm 6.03 tightbore and can get up to 500fps with the standard blue nozzle. I regulate down with my PSI to get in to field ranges-ending at about 80-85PSI for 400fps. I have a red nozzle, but never use it. With a wide bore it might be usable. I also use the Prowin R-hopped, but should probably have an ER-hop since I run at least .32g BBs-usually .36g or more.

Keep in mind, some fields/events might not accept the FCU setting a "permanent semi-only" when running that FPS range.