|
|
Post by comradetom on May 26, 2011 14:01:32 GMT -5
I just purchased an enhanced recoil spring for my KJW M9 from Evike. I have gotten the spring on the slide. Now I just have to get the upgraded hammer spring in. Unfortunately this is the first time I have ever modified this or any gun of mine, and I am having a hard time getting the pin out that holds in the bottom stopper on the hammer spring. Has anyone done this upgrade to a similar TM clone gun or have any advice about doing the Hammer spring swap?
Any help or advice is greatly appreciated,
Tom
|
|
|
|
Post by Shanker on May 26, 2011 14:46:46 GMT -5
I know that TheEnd has done a disassembly guide with pictures and the link is in his signiture, so I'd check that out.
|
|
|
|
Post by TheEnd on May 26, 2011 21:01:18 GMT -5
The link to the guide is in my signature below.
Are you talking about the pin on the base of the grip near the lanyard loop? If so you have to push the lanyard loop up a little while you push the pin out. The center is slightly grooved to prevent the pin from simply falling out.
|
|
|
|
Post by comradetom on May 27, 2011 9:01:29 GMT -5
Thanks, I got the pin out and the new spring installed. Hoping the gun will function fine now, it was too cold for me to test yesterday.
|
|
