Removing buffer spacer for GBBR

[Exile]

Hey guys, I am having trouble removing the buffer spacer my GBBR. It's stuck really tight in there and I really need to get it out so I can add my Milspec stock. Any ideas?

[Thor]

The buffer spacer? Do you mean the plate on the outside of the buffer, that people often replace with one point mounts?

Those buffer tubes come off similarly to RS ones, so there should be a spring loaded pin that goes into that plate. That's probably where you're getting stuck. You should be able to access the pin from the inside of the lower receiver and retract it. Also, if you don't have one, get your hands on an armorer's wrench at least, if not an armorer's block too.

[Exile]

Not quite. Inside of the tube there is a rubber spacer to prevent the bolt from sliding too far past the hammer. Thats what I am trying to remove.

[Thor]

Hmm... I'm not quite sure I know what you're talking about then. What brand GBBR do you have?

[Exile]

We, but both the WE and WA use the same type of buffer spacer.