Clip charging trouble ? or am i just messing it up

[Bishop]

You guys ever have trouble getting gas in your clips. I got a Tac master and I seam to be having issues getting gas in the clips. Sometimes I can get it to take a good charge and other times I cant seam to get it to take enough gas for more than two shots. I though that I might not be holding it at the correct angle. I have tried every nuance of angles. But Most of the time I just seam to smell up my house. The manual is no help seeing I cant read it. So any help you guys can give a new guy would be most uuuummmm helpful.

[Bigmack]

1) remove magazine from weapon
2) hold magazine upside down vertically
3) gas vertically (in relation to the Valve. not the magazine) for 5-10 seconds


that should do it. there should be very little...if any gas leakage while you're gassing up the mag.

[Bishop]

Yea it seams to be leaking all over the place for me. It will spit and sputter

[Dawg Bait]

with the Beretta Mags you should hear a tiny little flow noise.. then it will stop.. my KJW uses TM mags so i always had them fill perfectly..


Ross
DAwg Bait

[Andree]

My socom has been doin that lately Im guessing you just need to spray some lube in that area... I havnt tried it but with gas guns when somthing goes wrong lube it up! A gas O ring could have gotten a bit wet... Swelled up and then dried out and be blocking the passage... Silicon Spray should be good and you can get a big can at home depot for like 1.50$