HotelSixActual
New Member
TM Sig 552, KWC Caspian .45 Owned: TM M4A1, KSC Glock 18c, KWC Glock 17
Posts: 816
|
Post by HotelSixActual on Feb 4, 2004 20:28:49 GMT -5
Hey im not sure if this is the right place but anyway i need to take apart my Sig 552, theres something rattling around inside (possibly one of the little hexes from the RIS mounts) but i cant figure out how to stip the thing down, i.e. take apart the reciver, it doesnt say in the manual and i cant find it anywhere online, can someone help me please?
|
|
21CA-Iceman
New Member
Owner of 21st Century Airsoft
Posts: 554
|
Post by 21CA-Iceman on Feb 6, 2004 11:31:09 GMT -5
I see not many have helped you on this one. If you are even close to us, I would be willing to open the repair centur up to you - No Charge - and I am willing to sit down with you in between customers and figure it out if you are interested.
|
|
HotelSixActual
New Member
TM Sig 552, KWC Caspian .45 Owned: TM M4A1, KSC Glock 18c, KWC Glock 17
Posts: 816
|
Post by HotelSixActual on Feb 6, 2004 16:35:54 GMT -5
Hey, wow thats really helpfull, Id deffinetly take you up on that but through a serise of randomly taking out screws i found out how to get it open but i never want to try dong it again because im sure i was pretty close to breaking something. But if i want to upgrade it i will deffinetly be sending it to you Bill if your up for it. Thanx
|
|
21CA-Iceman
New Member
Owner of 21st Century Airsoft
Posts: 554
|
Post by 21CA-Iceman on Feb 6, 2004 16:47:41 GMT -5
I know at times that these airsoft guns can be a real pain the a$$ and you are right, getting frustrated usualy leads to breaking something. I am glad to hear that you got it.
|
|
Mitch1313
New Member
SigFive-Fifty-Two ___ Mac11-CQBII___ SteyrSPP
Posts: 136
|
Post by Mitch1313 on Feb 19, 2004 23:32:44 GMT -5
pop off the battery cover, slide the lower plastic sliding piece forward and pull it off from the rear of it. take out the upper screw at the back of the gun while the stock is collapsed. remove the gas cap at the front(the one that u push the button in and twist it) and take out the screw. take off the flash hider and o ring and slide off the meatal piece behind it. take out the two small screws on each side which are normally covered by the battery cover and unscrew the battery cradle and remove it. snip off the ties that are holding the fuse case in its place. slide forward the metal barrel and structure in front, with a lot of force while pulling on the upper part of the body forward. when the uper part of the body stops you may need to lift it upwards over any detaining pieces as you slide it forward.make sure to slide the metal barrel completely forward over the inner barrel. As you slide everything forward keep aware of the fuse wires and the battery connector wires as they may need to be hassled around and between parts, to prevent them from gettin caught up in it. i have know i dea what the pieces are actually called so let me know, but thats how you take it apart. and remember where your screws go.
|
|
