Solid Snake 00
New Member
Banned until 8/14
TM M4A1SD, working on HK M4 built from scratch
Posts: 347
|
Post by Solid Snake 00 on Nov 5, 2003 16:43:35 GMT -5
Yea, I was just wondering you think the stock Tokyo Marui gears will last with a M120 spring? What are the TM stock gears made out of? Thanks in advanced.
|
|
|
|
Post by Bigmack on Nov 5, 2003 17:51:40 GMT -5
answer: they would for a short while. don't expect to get more than a couple hundred rounds out of them, however.
what are they made of? alluminum. specifically, melted down pop cans.
|
|
Andree
New Member
No one will fear me... How can you fear somthing that you have never seen,at its full potential
Posts: 464
|
Post by Andree on Nov 6, 2003 0:28:27 GMT -5
M120? is that a 120% spring...
Bigmack from what i have gathered from all the other posts about other guns they said that the guns should last for a while aslong as you dont go over 150%
Am i wrong? were thoes conclusions just for the other guns...mp5's, is there a diffrence between the TM mp5 and TM m4 Gears?
|
|
|
|
Post by Munin on Nov 6, 2003 10:15:31 GMT -5
M120 is not the same as a PDI 120%. The Systema springs are rated in meters per second of velocity they'll give a pellet of a certain weight. 120 m/s is just shy of 400 FPS, which is not a PDI 120%, but rather a PDI 170% spring.
|
|
Andree
New Member
No one will fear me... How can you fear somthing that you have never seen,at its full potential
Posts: 464
|
Post by Andree on Nov 6, 2003 10:31:27 GMT -5
Gotchya Thanks a lot munin! so the m is for meters per second, and pdi is for 120% and all that... thanks again!
|
|
