bobalis
New Member
TM M733 upgraded, KSC glock 19, BH crossdraw vest OD
Posts: 735
|
Post by bobalis on Oct 12, 2003 18:55:13 GMT -5
When I was at Peg Wind my glock broke and at the time i didn't know what was wrong. Now I know and its the hammer releasing mechanizem(sp), its not releasing. When I take the slide off and I cock the hammer back, i see this little piece of plastic that is under the hammer and when i pull the trigger, its not getting moved and since it isn't moving, the hammer isn't releasing. I took a pencil and when i pushed it down, the hammer did release. Can anyone tell me how to fix this problem?
My GBB is a KSC Glock 19 all stock.
|
|
|
|
Post by Knief on Oct 12, 2003 19:44:00 GMT -5
this little piece of plastic isn't the disconnector, is it? Because if it is, then that's not the problem because that is what's supposed to happen. It stops the hammer from dropping again unless the slide has returned completely to battery. It's a fail safe system to ensure that the next shot is chambered (or the airsoft equivelent) and everything is seated properly before putting another surge of gas through the system.
|
|
bobalis
New Member
TM M733 upgraded, KSC glock 19, BH crossdraw vest OD
Posts: 735
|
Post by bobalis on Oct 12, 2003 20:10:50 GMT -5
I don't know if it the disconnecter( i should probably find out). But I do know that when the hammer is cocked back and push down on this thing, the hammer gets uncocked.
|
|
