shrapnel
New Member
Roaaar!!!!
Posts: 318
|
Post by shrapnel on Sept 14, 2003 18:40:07 GMT -5
sometimes it doesnt pull back all the time, the trigger gaurd like gets in the way and the screw goes to far in to keep the back together, it goes in to far where the bolt wont go back. someone give me some solutions
-ShRApNel
|
|
|
|
Post by Newman on Sept 14, 2003 18:57:52 GMT -5
Perhaps you disassembled it and put back the large "washer with teeth" on backwards?
I'd suggest you just check out the internals. It'll take less than 5 minutes to open it up.
|
|
shrapnel
New Member
Roaaar!!!!
Posts: 318
|
Post by shrapnel on Sept 14, 2003 19:15:54 GMT -5
there wasnt a washer :S
|
|
|
|
Post by Newman on Sept 14, 2003 20:01:50 GMT -5
....There is a piece of metal...you know...grey matter....that is grey...and it looks flat, like a washer, but is not a washer....and it has teeth on it...and it's grey...and it can go in backwards, if you point the teeth in the wrong direction.
It's grey, remember. Grey.
|
|
|
|
Post by Motown on Sept 14, 2003 20:11:35 GMT -5
Grey or Gray? ;D
|
|
shrapnel
New Member
Roaaar!!!!
Posts: 318
|
Post by shrapnel on Sept 14, 2003 21:27:43 GMT -5
That is there. if im not mistakein the trigger gaurd is in the way. ill give it a wack. it look like the cylinder is fine it in the rigger area
|
|
