versenyen
New Member
Has Been Ban'd
Try to look unimportant; the enemy may be low on ammo and not want to waste a bullet on you.
Posts: 33
|
Post by versenyen on May 15, 2003 22:20:16 GMT -5
My friend has a JAC M16A1 Gas gun. The gas hold is in the stock and after we fill up the gun there is a slight hissing commin from the fill point for the gas. We hit it a few times and mess with it for a sec then the leak stops. What does that mean on how its leakin. Is there somthing messed up? or do they just do that (ive noticed it has done that to his TM SOCOM, and my KJW USP atleast once before. How can we stop this?!?! Thanks in advance.
|
|
Grunt22
New Member
TM M16A2, KWC 1911, KWC P226, HFC M16A1
Posts: 338
|
Post by Grunt22 on May 15, 2003 22:29:01 GMT -5
It could possibly be some loose parts internally inside of the stock, which happened when my friends reciever in his KWC Gas M16 got a very small crack in it... this allowed metal internals to shift slightly, causing a leak to sputter off every now and then. My only guess would be to dissassemble and make sure it is solid and not shifting around inside of the stock, that's what we had to do.
- Grunt22
|
|
|
|
Post by Hadoken on May 17, 2003 14:46:13 GMT -5
Since the JAC M16A1 is a classic rifle you could try asking for some help over on the classic airsoft forums at.. ta-daaa.. www.classicairsoft.net |
|
|
|
Post by viper1 on Sept 7, 2003 16:40:51 GMT -5
i had some magazines that i filled up use to leak at the fill point. i took them to airsoft extreme and he fixed it. all he did was shoot some lubricant in it and it stop leaking. the seals just got dry. he used i think was silicone spray. i hope this can help you. henry
|
|
|
|
Post by SnowPanther on Sept 7, 2003 16:59:33 GMT -5
this member isn't here at all so I dont think the info will help him
|
|
