|
|
Post by TheBadGuy on Aug 26, 2003 12:44:05 GMT -5
I just installed a m100 spring and metal bushings. After putting the gun back together and testing it, it shot a couple of rounds then jammed. I then moved the selector switch to full auto and the gun worked again. I was using it today and the gun jammed again on semi. I would shoot about ten rounds and then it would jam, thne it would not jam on full auto even after emptying an entire clip. Does any one know whats wrong?
|
|
HotelSixActual
New Member
TM Sig 552, KWC Caspian .45 Owned: TM M4A1, KSC Glock 18c, KWC Glock 17
Posts: 816
|
Post by HotelSixActual on Aug 26, 2003 13:00:15 GMT -5
How does it jam? Like you cant pull the trigger or like you pull the trigger and nothign happens? Sometimes my M4 wont work on semi because the trigger goes stiff like its saftied or something.
|
|
|
|
Post by TheBadGuy on Aug 26, 2003 15:33:16 GMT -5
it jams like its on saftey. This never happened before the upgrade, but I also almost never shot the gun on semi.
|
|
|
|
Post by Newman on Aug 26, 2003 17:22:57 GMT -5
You might have bumped and/or nudged the selector switch parts when you took out the mechbox, or possibly you moved the selector plate (on the side of the mechbox) just a little too far so that, when you go to semi, it's actually on the edge of safety, and when you go to full-auto, you're just past single.
Heck, you might have just not put in a part that fell out during the spring and bushings installation.
Pictures of the 'box might be nice.
|
|
