Post by bong on Jun 14, 2003 8:51:54 GMT -5
bascially when i pull the bolt back all the way, the sear (i think thats what its called) does not engage. Therefore the spring doesnt stay compressed, and the bolt just flies back to the original position when i let go. Usually it stops, then you have to push it back.
i think i messed it up when i took apart the gun without a manual. I was reading the article at arniesairsoft.co.uk
it says "
Step 5 - Now that you have done that, take a look at the trigger assembly, unscrew the 2 screws at either ends of the trigger assembly to remove it from the receiver. Be sure to look at the 2 little springs around the steel piece and remember what position they are in, if these are not put back in the same way as they were the piston will not be held back when the bolt is cycled."
i read that article after i disassembled and reassembled, so i dont know where the springs were before. Does anyone know how to fix it? Ive been told its a pretty common problem with m24's and aps2's alike.
i think i messed it up when i took apart the gun without a manual. I was reading the article at arniesairsoft.co.uk
it says "
Step 5 - Now that you have done that, take a look at the trigger assembly, unscrew the 2 screws at either ends of the trigger assembly to remove it from the receiver. Be sure to look at the 2 little springs around the steel piece and remember what position they are in, if these are not put back in the same way as they were the piston will not be held back when the bolt is cycled."
i read that article after i disassembled and reassembled, so i dont know where the springs were before. Does anyone know how to fix it? Ive been told its a pretty common problem with m24's and aps2's alike.