|
Post by Vicious (Freelance) on Jul 5, 2012 10:29:31 GMT -5
Ok I am putting this thread here because people are so far confused as far as what parts to buy as upgrades go. So here is a list of what I can tell you so far. The cylinder it self is a VSR, so a laylax or PDI will work. (I haven't ordered mine yet will update when I receive.) The internals, piston, piston head, spring guide (if it matters) are aps2. The trigger is the same as the CA m24. The stock inner barrel is already a 6.035 tight bore. No need to change this. The hop up unit is different it is a hybrid of a vsr and a aps2. The hop up construction is more similar to a/an aps2 but this stock hop up adjusts like a vsr hop up. So in my opinion it should take a/an aps2 aftermarket hop up unit, but could be an M24. This should only change where you adjust said hop up unit. I have tried a vsr hop up by angel custom and right away I could tell it wasn't the same. This is why I believe it will accept a/an aps2 aftermarket unit. The magazine is unique to the snow wolf m99/ m24 they are as cheap as my "ex" pick up a lot at $12 each they are easy to acquire. So in short this is a hell of a rifle to work on, but in my opinion more than worth it if you are willing to put in work and do some research.
|
|
|
Post by redalert on Jul 5, 2012 19:41:05 GMT -5
This should go under the spring section. Take some measurements of the hop-up unit, diameter and length and snap a few pictures while you're at it and I'm sure someone will be able to figure out if the aps hop-up unit will work or not.
|
|
|
Post by deacon on Jul 6, 2012 16:05:33 GMT -5
Any proof that the cylinder is a VSR?
|
|