OXIDE
New Member
Posts: 50
|
Post by OXIDE on Dec 26, 2014 20:37:34 GMT -5
I have done a lot of searching and not found much so sorry for posting. But my problem is that the selector switch is extremely hard to move. The only thing i did was take out the motor and pistol grip! So anyone know how to fix this? Its a elite force m4 cqb. Thanks!
|
|
T6e9a
New Member
Back in business
Posts: 911
|
Post by T6e9a on Dec 26, 2014 21:18:32 GMT -5
Did the gearbox move at all when you took off the pistol grip/motor?
|
|
|
Post by luke213 on Dec 26, 2014 21:51:09 GMT -5
I'd take and split the upper off the gun just let it pivot on the front pin. Then take a look into the lower and see how the selector switch is hitting the selector plate or if anything is screwy there.
I'm basing this off tm guns and some of the cheaper aegs I saw a few weeks ago which generally seem like tm clones so I may be incorrect for the gun but it's highly likely this part is the same.
Luke
|
|
T6e9a
New Member
Back in business
Posts: 911
|
Post by T6e9a on Dec 26, 2014 22:06:37 GMT -5
As the CQB is 1 piece hopup, you will need to remove the front pin, and slide the upper off, past that, do what Luke suggested.
|
|
|
Post by luke213 on Dec 26, 2014 22:27:56 GMT -5
Ah then it's like my CA's;)
I can't imagine how something would have gone wrong pulling the grip unless something is loose and blocking the selector switch or something like that. Maybe a tab on the upper came loose or broke etc. Either way there isn't much that effects the selector plate it's a pretty simple part of the system.
Luke
|
|
OXIDE
New Member
Posts: 50
|
Post by OXIDE on Dec 26, 2014 23:33:20 GMT -5
Ah then it's like my CA's;) I can't imagine how something would have gone wrong pulling the grip unless something is loose and blocking the selector switch or something like that. Maybe a tab on the upper came loose or broke etc. Either way there isn't much that effects the selector plate it's a pretty simple part of the system. Luke After a while of moving it back and forth it finally freed up. But now its loose and doesn't click when i switch it. It also sounds like its rubbing on something?
|
|
|
Post by luke213 on Dec 27, 2014 0:28:02 GMT -5
Only way to know is to tear off the top and look. It's not a hard process and that's the only way to know what's going on in there.
|
|