Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Jun 27, 2014 8:41:15 GMT -5
Okay so I recently bought a WE hi capa 4.3, I bought a angel tight bore barrel fot it and it said it fits hi capa, I did not realize there was more than one type if hi capa, any way so it is ment for a glock or tokyo mauri airsoft pistol and it fits fine into mine but the part I am supposed to put the bucking on is about twice as long as it is in the stock barrel. My question is if i could just cut this down to the same size and it would work fine or if I should just return it, which I do not really want to do since shipping would be almost as much as a bew tightbore barrel. I am talking about the part with the gap, about twice as long as that on the stock barrel. My second part to this question is where to finda new hop up gear. This is my first gbb and when I put it back togethor I did not exactly do it 100% correct and since the geqr is made of plastic, when I put the metal part in the middle of the gear it must have came out and it poked into the side if it an now I can only adjust the hop up about half way. I am not going to put a picture of the damage because I do not want to take it apart again but I will send a picture of the gear. It must cost less than 5 cents I just can't find one anywere. thank you for any help and please excuss any spelling errors
|
|
Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Jun 27, 2014 8:46:46 GMT -5
That image is a little bit blurry let me see if this one will be better
|
|
|
Post by Deacon on Jun 27, 2014 16:35:52 GMT -5
If Evike advertised it as a Hi-Capa barrel and it doesn't fit: Get an RMA and send it back. You shouldn't have to pay for it. Cutting a barrel is generally bad news bears unless you have the right tools/knowledge. www.evike.com/products/45249/
|
|
Elvis
New Member
Formerly BobHuckins
Posts: 233
|
Post by Elvis on Jun 27, 2014 17:15:26 GMT -5
If Evike advertised it as a Hi-Capa barrel and it doesn't fit: Get an RMA and send it back. You shouldn't have to pay for it. Cutting a barrel is generally bad news bears unless you have the right tools/knowledge. www.evike.com/products/45249/It is advertised for a 5.1 but it cut off at "we hi capa..." So I failed to see the 5.1 part. My grampa has a full blown work shop so I am not too concerned about doing it wrong. I emailed evike though. Thank you for your help
|
|