|
Post by karils on Nov 21, 2012 15:51:33 GMT -5
I got a kwa MP7 off of ebay, and from obvious results the magazines are leaking extremely fast. I took apart the mag yesterday, and just re oiled the o ring in the bottom, but it still leaks... Is there any other things I need to check at all on the magazine? I don't think it leaks through the release valve, but at the same time nothing seems to be leaking (even the bottom, don't get a smell of propane coming from it when I fill it). The propane can is a new one, so in theory that should not be the problem, but I wouldn't be all that surprised.
|
|
drewroud
New Member
Lipo ready hop up unit
Posts: 486
|
Post by drewroud on Nov 21, 2012 16:40:39 GMT -5
Could be a leak from the inside of the valve, there is a small o ring inside the actual valve. Check that it isnt leaking from the valve on top, where the gas leaves. I hate when they leak there.
|
|
|
Post by karils on Nov 21, 2012 16:46:01 GMT -5
I don't understand how to take apart the top/get to where the o ring on the top/release valve would be, though I assume there is a way...
|
|
|
Post by karils on Nov 21, 2012 17:35:40 GMT -5
Well, seems as if every time I try and fill it, it works a bit better... First few times it was like 3-5 shots, then like ten, last one was 31.. Running some silicon oil through it may have fixed it.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 5, 2012 20:02:23 GMT -5
Go on evike.com and type in moondog o-rings. they will work with the MP7
|
|