|
Post by Bulletproof on Aug 16, 2012 22:05:41 GMT -5
Hello all, I was working on my WA Wilson Combat Pro today and noticed that BBs were getting stuck in the hop-up chamber. So, after printing out an exploded diagram, I set to work. Once I had the strange chamber apart, I looked for things that could possibly go wrong. When doing this I found 2 extremely small (I mean TINY, like 1mm in diameter) balls, which took some effort to figure out where they belong. I found one on top of a tiny spring that applied pressure to the allen screw that pressed up on the hop-up. Once in careful place, I tried to find where the other ball went. When testing a theory, I must have knocked the allen key out of place, because the tiny spring and tiny ball went flying, never to be found again. I'm not sure if these various tiny parts are available, well, anywhere, if they are please tell me. Otherwise, I was looking for a complete hop-up chamber for an SCWI/SV, and I STILL can't find it anywhere? Any suggestions? Am I completely fucked?
Also, I'm looking for the proper O-ring size for the nozzle. If you know the size, please let me know.
Thanks for any help in advance.
|
|
Italian
New Member
Phil Team 5
Posts: 302
|
Post by Italian on Aug 18, 2012 17:36:54 GMT -5
I've looked for those balls online before when I was modding one of my SCW chambers. I'll look around for to see if I can find anything. They're both the same size, though, so if you measure the other one and search for the size online you might have some luck.
|
|
|
Post by Bulletproof on Aug 18, 2012 18:14:05 GMT -5
My current idea is to measure the remaining ball, either buy it or have it made, then use the diameter of the ball to give the approximate diameter of the spring, then buy or have that made.
|
|
|
Post by Mles on Aug 19, 2012 15:56:34 GMT -5
You will need a whole new unit. Contact Ehobby or WGCshop and see if they have OEM parts.
|
|
|
Post by Bulletproof on Aug 19, 2012 23:19:19 GMT -5
You will need a whole new unit. Contact Ehobby or WGCshop and see if they have OEM parts. I'm going to measure the ball and try to get parts. I can't find OEM or upgrade parts at WGC, Ehobby, or UNCompany. I didn't try to contact them, but I doubt they would have it. I've googles it and this thread is actually the #2 result! I didn't know WA parts were this hard to find.
|
|
|
Post by Mles on Aug 20, 2012 22:31:18 GMT -5
They aren't. Contact the retailers I said and they will find you them. If worst comes to worst, contact Parts_Man on Tradersairsoft.com
|
|
|
Post by Bulletproof on Aug 26, 2012 14:41:30 GMT -5
After looking for the ball and spring themselves looks like I'd spend $20 plus shipping and I'd have lots of extras, so I think buying the OEM part would be not too much more expensive and less of a pain in the ass.
Thanks for all responses so far, I will let you know how this turns out.
|
|